ARC MX FG, Abrasion Resistant Coating for Fine Particle Wear
ARC MX FG is a trowel applied 100% solids, zero VOC, ceramic-reinforced epoxy coating designed for protecting surfaces against dry and wet slurry abrasive flow. This two-part system complies to 21 CFR 175.300 and is suited for direct food contact.
Use ARC MX FG to:
- Protect metal surfaces from extreme sliding-wear and abrasion caused by fine particles
- Restore worn equipment to near original condition
- Provide a longer lasting alternative to rubber linings and ceramic wear tiles
- Resist a broad pH spectrum
- Easily apply by trowel
- Description
- Request a Quote
Description
- Tough, ceramic-reinforced coating that resists broad range of slurries
- Extends life of equipment exposed to fine particle wear
- Complies with 21 CFR 175.300 for direct food contact as follows:
- Type II – Acidic (pH 5.0 or below), aqueous products; may contain salt or sugar or both, including oil-in-water emulsions of low orhigh fat content food.
- Type III – Aqueous, acid or nonacid products containing free oil or fat; may contain salt, and including water-in-oil emulsions of low orhigh fat content.
- Type IVA – Dairy products and modifications: Water in oil emulsion, high or low fat.
- Type IVB – Dairy products and modifications: Oil in water emulsion, high or low fat.
- Type V – Low moisture fats and oils, Condition C.
- Type VIII – Dry solid foods.
Application Areas:
- Cyclones
- Wear plates
- Cleaner cones
- Valves
- Slurry pumps
- Pipe spools
- Hopper bins
- Agitators
- Pipe elbows
- Transport screws
- Mixers
- Pulverizers